Engineering Plastics
Practical engineering plastics guides covering material selection, processing, applications and purchasing specifications.
-

Engineering Plastic Chemical Resistance Testing
Plan chemical-resistance tests using the actual fluid, concentration, exposure and assembly stress, with defined criteria and unexposed controls.
-

Dimensional Stability of Engineering Plastics
Define measurement timing, conditioning and critical dimensions for engineering plastics. Link inspection results to cavity, material and process data.
-

Glass-Filled Nylon: Strength, Warpage and Fit
Evaluate glass-filled nylon by load path, conditioning, flatness and assembly performance. Compare reinforcement levels with the actual tool and part.
-

PET Bottle Flakes vs Engineering PET Resin
Distinguish PET flakes, pellets and engineering compounds by feedstock form, preparation, contamination requirements and the intended conversion route.
-

PBT for Electrical Components: Grade Approval
Review PBT grade identity, reinforcement, drying and relevant electrical or flame documentation before testing connectors and assembled components.
-

POM Gears and Sliding Parts: Specification Guide
Specify POM gears and sliders by load, speed, mating material, lubrication and fit. Use a mechanism trial to assess wear and dimensional performance.
-

PMMA vs PC for Transparent Plastic Parts
Compare PMMA and PC for transparent components using optical targets, impact exposure, finishing and total conversion cost rather than clarity alone.
-

Polycarbonate Parts: Clarity and Assembly Checks
Specify polycarbonate clarity at the actual part thickness, then check fasteners, cleaners and molding conditions on representative assembled parts.
-

Engineering Plastic Drying: A Production Checklist
Plan resin drying with grade-specific instructions, dryer and transfer controls, and suitable moisture measurements before molding or extrusion.
-

PA6 vs PA66: Grade Selection and Conditioning
Compare PA6 and PA66 using matched reinforcement, moisture conditioning and service conditions. Plan dimensional and assembly tests for nylon parts.